Audison bit One HD User Manual

58
USER'S MANUAL
bit One HD /
6. Once you have clicked on OK, the Firmware update
procedure starts. This process will last between 30
seconds and 1 minute; the progress bar and the
flashing logo on the bit One HD will show the updating
process status.
7. Place the “UPGRADE” switch to OFF position.
8. Disconnect and the connect again the bit One HD
terminal block.
9. Turn bit One HD back on and restart the PC software.
If bit One HD rmware update has been completed
correctly, the dialog window will display the following:
- new bit One HD Firmware version.
10. Repeat the product calibration operations
(see sec. 7.2).
USB
Update
A
ON OFF
B
TARGET MODE
9

Audison bit One HD Specifications

General

Brand	Audison
Model	bit One HD
Category	Signal Processors
Language	English