AUMA SA Series User Manual

659.6.2. Direction of rotation at hollow shaft/stem: check
659.6.3. Limit switching: check
6710. Commissioning (settings/options in the actuator).............................................................
6710.1. Switch compartment: open/close
6810.2. Mechanical position indicator (self-adjusting)
6810.2.1. Mechanical position indicator: set
6910.2.2. Gear stage of the reduction gearing: test/set
7010.3. Mechanical position indication via indicator mark (not self-adjusting)
7010.3.1. Mechanical position indicator: set
7110.3.2. Gear stage of the reduction gearing: test/set
7411. Corrective action....................................................................................................................
7411.1. Faults during commissioning
7411.2. Fault indications and warning indications
7811.3. Fuses
7811.3.1. Fuses within the actuator controls
7911.3.2. Fuse replacement
7911.3.2.1. Replace fuses F1/F2
8011.3.2.2. Test/replace fuses F3/F4
8011.3.3. Motor protection (thermal monitoring)
8112. Servicing and maintenance...................................................................................................
8112.1. Preventive measures for servicing and safe operation
8212.2. Maintenance
8212.3. Disposal and recycling
8313. Technical data.........................................................................................................................
8313.1. Technical data Multi-turn actuators
8513.2. Technical data Actuator controls
9114. Spare parts.............................................................................................................................
9114.1. Multi-turn actuators SA(V) 07.2 – SA(V) 16.2/SAR(V) 07.2 – SAR(V) 16.2
9314.2. AC 01.2 actuator controls with SJ electrical connection
9514.3. AC 01.2 actuator controls SF compact
9715. Certificates..............................................................................................................................
9715.1. Declaration of Incorporation and EU Declaration of Conformity
98Index........................................................................................................................................
101Addresses...............................................................................................................................
4
SA 07.2 – SA 16.2 / SAR 07.2 – SAR 16.2 Control unit: electronic (MWG)
Table of contents AC 01.2 Non-Intrusive EtherNet/IP

AUMA SA Series Specifications

General

Torque range	10 Nm to 32, 000 Nm
Protection class	IP68
Ambient temperature	+70°C
Voltage	24V DC
Communication	PROFIBUS DP, MODBUS RTU, Foundation Fieldbus
Certifications	ATEX, IECEx, CSA, GOST, SIL
Control	Local, Remote, Bus (PROFIBUS, MODBUS)