AUMA SA-UW - SF Electrical Connection (AUMA Plug;Socket Connector)

5.3. SF electrical connection (AUMA plug/socket connector)
Figure 16: SF electrical connection
[1] Cover of actuator controls electrical connection (XK) – (SF version)
For customer connection of power supply and e.g. to control room
[2] Socket carrier with screw-type terminals
[1]* Cover of wall bracket plug socket connector (XM) – (S version)
The plug/socket connector of LSW 68 cable set is readily assembled (wired)
For LSW 69 cable set, the plug/socket connector must be opened and the
cables must be connected to the pin carrier.
[2]* Pin carrier with crimp-type connection
Short description
Plug-in electrical connection with screw-type terminals for power and control contacts.
Control contacts also available as crimp-type connection as an option.
SF version. For power and control cable connection, remove the AUMA plug/socket
connector and the socket carrier from terminal compartment. Removing the cover
is sufficient for connecting the fieldbus cables.
Technical data
Table 13:
Electrical connection via AUMA plug/socket connector
Control contactsPower contacts
50 pins/sockets6 (3 equipped) + protective
earth conductor (PE)
No. of contacts max.
1 to 50U1, V1, W1, U2, V2, W2, PEDesignation
250 V750 VConnection voltage max.
16 A25 ARated current max.
Screw connection, crimp-type (option)Screw connectionType of customer connection
2.5 mm
2
(flexible or solid)
6 mm
2
(flexible)
10 mm
2
(solid)
Connection diameter max.
20
SA 07.2-UW – SA 16.2-UW / SAR 07.2-UW – SAR 16.2-UW Control unit: electronic (MWG)
Electrical connection AC 01.2 Non-Intrusive Profinet