AutoCrib RoboCrib 2000 E - Platter too slow during full speed part of the move; Move Cycle

Appendix
43 | P a g e
S Code
Error
Action
Message
S3
Platter too
slow during
full speed
part of the
move.
1. Take no action
2. Throw error
3. Lock the screen.
“Possible Jam on Platter r
X See Supervisor”
Notes: An S3 error is usually a soft jam and is caused by an item that is pinched between the chain and a
sprocket. This almost always happens on the LSP or serpentine chain. The administrator should remove the
side panel and inspect the chain for any obstructions. Clear any obstructions and restart the machine so it
recalibrates.
Speed
Time
Accel.
Ramp
Move Cycle
Decel.
Ramp
S3
Full speed part
Of move
Check 1
Check 2
Fetch Begins
Fetch Ends