Installation
Installation and Commissioning Handbook, AutroMaster ISEMS - Integrated Safety and Emergency Management System,
116-P-AMASTER-INSTCOMM/IGB, Rev. C, 2016-05-20, Autronica Fire and Security
Page 37
To change the network information for the selected network
interface, click Edit.
Check that Enable Ipv4 support is ticked off.
Select Manual configuration.
Type the IP address and Netmask (for example,
192.168.1.1/255.255.255.0).
Disable Ipv6 support (remove tickoff mark).
If several network cards is used in the PC, the procedure has to be
repeated for each card.
Under the hostname, make sure that manually is selected, and type
the PC’s hostname, for example, “am5000”.
To continue, click Next.
To Next Page
Loading...