While on an active call
168
Using the Call Park feature
You can use the Call Park feature to temporarily park a call so that you or
another user can retrieve the parked call from another phone. Using Call
Park does not tie up a line, because the call is held on the IP Office call
server.
To park a call:
1. Press the Feature soft key.
2. Enter 74 on the keypad.
3. Press the Enter key, located in the
center of the navigation key.
The deskphone displays the following
prompt: PrkOn:>
4. Using the key pad, enter an ID for the
parked call. Enter an ID that is up to 9
digits in length. You will need to enter
this ID when you retrieve the call from
park.
5. Press the Enter key.
Note: If there is currently an active
called parked that uses the same ID as
the one you have entered, the
deskphone displays Forbidden. Enter a
new ID.
Feature
Park
To Next Page
Loading...
