Showing EAPOL multihost
Identify the EAPOL multihost information.
1.
Use the show eapol multihost command to display the multihost
information.
2. Note the state of Allow Use of RADIUS Assigned VLANs.
Enabling use of RADIUS assigned VLANs
Change the "allow RADIUS assigned VLAN" to "enable".
1. Use the eapol multihost use-radius-assigned-vlan command to allow
the use of VLAN IDs assigned by RADIUS.
2. Ensure that there are no errors after execution.
Showing EAPOL multihost interface
Display the EAPOL interface information.
1. Use the show eapol multihost interface <port#> command to display
the interface information.
2. Note the status of ALLOW RADIUS VLANs.
Showing VLAN config control
Display the VLAN config control information.
1. Use the show vlan config control command to display the information.
2. Identify if config control is set to strict.
Changing VLAN config from strict to flexible
Set the VLAN config control to flexible to avoid complications with strict.
1. Use the vlan config control flexible command to set the VLAN config
control to flexible.
2. Ensure that there are no errors after execution.
Troubleshooting authentication
100 Troubleshooting 5.1 February 2013
Comments? infodev@avaya.com
To Next Page
Loading...
