Variable Value
this value to zero (0), the default port is
used.
agent ip address <A.B.C.D> Configures the agent IP address. If no IP
address is specified, the default value is
0.0.0.0, which causes the agent to use the
switch/stack IP address.
agent port <0–65535> Configures the UDP port for agent-server
communication. The agent receives
discovery packets on this port. The default is
port 5001
1.
The server must use the same port.
cli-timeout <60–600> Configures the CLI timeout value in seconds.
The default is 60 seconds.
Note:
The CLI commands only impact the SLM
CLI and not the standard platform CLI.
oper-mode enable Enables the SLA Monitor agent. The default
is disabled.
If you disable the agent, it does not respond
to discover packets from a server.
If you disable the agent because of resource
concerns, consider changing the server
configuration instead, to alter the test
frequency or duration, or the number of
targets.
server ip address {A.B.C.D} [{A.B.C.D}] Restricts the agent to use of this server IP
address only. The default is 0.0.0.0, which
means the agent can register with any
server.
You can specify a secondary server as well.
server port <0–65535> Restricts the agent to use of this registration
port only. The default is 0, which means the
agent disregards the source port information
in server traffic.
The agent must use the same port.
Configuring SLA Monitor using EDM
Use this procedure to configure SLA Monitor
.
Configuring SLA Monitor
82 Troubleshooting 5.1 February 2013
Comments? infodev@avaya.com
To Next Page
Loading...
