Lowering EAP max MAC
Lower the eap-mac-max value to match the users.
1.
Use the eapol multihost eap-mac-max command to set the mac-max
value.
2. Ensure that there are no errors after execution.
Set EAPOL request packet
Change the request packet generation to unicast.
T
ask flow Set EAPOL request packet
The following task flow assists you to set the EAPOL request packet to unicast.
Figure 39: Set EAPOL request packet
Setting EAPOL request packet globally
Globally change the EAPOL request packet from multicast to unicast.
EAP multihost repeated re-authentication issue
Troubleshooting 5.1 February 2013 95
To Next Page
Loading...
