There are three attributes that the RADIUS server sends back to the NAS (switch) for
RADIUSassigned VLANs. These attributes are the same for all RADIUS vendors:
• Tunnel-Medium-Type – 802
• Tunnel-Pvt-Group-ID – <VLAN ID>
• Tunnel-Type – Virtual LANs (VLAN)
Configure switch
The VLAN must be configured correctly on the Ethernet Routing Switch 3500 Series device.
T
ask flow Configure switch
The following task flow assists you to configure the VLAN on the device.
Figure 42: Configure switch task
EAP RADIUS VLAN is not being applied
Troubleshooting 5.1 February 2013 99
To Next Page
Loading...
