address. Use the recovery tree in this section if you cannot access the standalone switch using
the stack IP address.
You cannot access a switch at the stack IP address using ping,
T
elnet, SSH, Web, or EDM recovery tree
About this task
If you cannot access a standalone switch in a broken stack of two units, even though you had
enabled the Stack Forced Mode feature, check that the standalone device still has a physical
connection to the network. The following figure shows the recovery tree for this scenario.
Procedure
Figure 16: Ping/Telnet/SSH/Web/EDM do not work when you use the stack IP address
Stack Forced Mode
Troubleshooting 5.1 February 2013 51
To Next Page
Loading...
