1. Follow local procedures and SOPs to reduce the number of devices connected.
2. Use the show adac in <port> command to display the ADAC information for
the port to ensure there are less than 16 devices connected.
Auto configuration is not applied
Correct some common issues that may interfere with auto configuration of devices.
Task flow Auto configuration is not applied
The following task flow assists you to solve auto configuration issues.
Figure 29: Auto configuration is not applied
Correct auto configuration
T
agged frames mode may be causing a problem. In tagged frames mode, everything is
configured correctly, but auto configuration is not applied on a telephony port.
Troubleshooting ADAC
76 Troubleshooting 5.1 February 2013
Comments? infodev@avaya.com
To Next Page
Loading...
