Avaya 3500 series - Reload ADAC MAC in Range Table

Figure 26: Correct filtering
Confirming port belongs to at least one VLAN
V
iew information to ensure that the port belongs to a VLAN.
1. Use the show vlan interface info <port> command to view the details.
2. Note the VLANs listed with the port.
Disabling the VLAN filtering of unregistered frames
Change the unregistered frames filtering of the VLAN.
1. Use the vlan ports <port> filter-unregistered-frames enable
command to view the details.
2. Ensure no errors after command execution.
Reload ADAC MAC in range table
Ensure the ADAC MAC address is properly loaded in the range table.
IP phone is not detected
Troubleshooting 5.1 February 2013 73