OR
default slamon cli–timeout—mode
14. To disable the agent automatic CLI session timeout, enter the following command:
no slamon cli–timeout—mode [enable]
15. To configure the agent server IP address, enter the following command:
slamon server ip address {A.B.C.C} [{A.B.C.D}]
16. To configure the agent server IP address to its default value, enter the following
command:
default slamon server ip address
17. To configure the server TCP registration port, enter the following command:
slamon server port <0–65535>
18. To configure the server TCP registration port to its default value, enter the following
command:
default slamon server port
Example
tbd
Next steps
If you have configured SLA Monitor yet the agent is not functioning as expected, determine
task status using the engineering menu.
If the agent is not in the expected state, reset the system to start the agent.
If the agent task functions as expected, perform typical troubleshooting steps to verify agent
accessibility:
•
Verify IP address assignment and port use.
• Verify that the SLA Monitor agent is enabled.
• Ping the server IP address.
• Verify the server configuration.
Variable definitions
The following table describes the parameters for the slamon command.
Variable Value
agent-comm-port <0–65535> Configures the port used for RTP and NTR
testing in agent-to-agent communication.
The default port is 50012. If you configure
Configuring the SLA Monitor agent using ACLI
Troubleshooting 5.1 February 2013 81
To Next Page
Loading...
