Procedure
1. Log on to Application Configuration mode in ACLI.
2. To configure the agent IP address, enter the following command:
slamon agent ip address {A.B.C.D}
3. To configure the agent IP address to its default value , enter the following command:
default slamon agent ip address
4. To configure the UDP port, enter the following command:
slamon agent port <0–65535>
5. To configure the agent UDP port to its default value , enter the following command:
default slamon agent port
6. To enable the agent, enter the following command:
slamon oper-mode enable
7. To disable the agent, enter the following command:
no slamon oper-mode [enable]
OR
default slamon oper-mode
8. To configure the agent-to-agent communication port , enter the following command:
slamon agent—comm—port <0–65535>
9. To configure the agent-to-agent communication port to its default value, enter the
following command:
default slamon agent—comm—port
10. To enable the SLA Monitor agent CLI support, enter the following command:
slamon cli enable
Note:
The CLI commands af
fect only the SLA Monitor CLI and not the standard platform
CLI.
11. To disable the SLA Monitor agent CLI support, enter the following command:
no slamon cli [enable]
OR
default slamon cli
12. To configure the agent automatic CLI session timeout value, enter the following
command:
[default] slamon cli–timeout <60–600>
13. To enable the agent automatic CLI session timeout, enter the following command:
slamon cli–timeout—mode enable
Configuring SLA Monitor
80 Troubleshooting 5.1 February 2013
Comments? infodev@avaya.com
To Next Page
Loading...
