Showing EAPOL multihost
Display the EAPOL multihost information.
1.
Enter the show eapol multihost command to display the information.
2. Ensure that Allow Non-EAPOL clients is enabled.
Enabling allow non-EAPOL clients
Correct the non-EAPOL client attribute.
1. Use the eapol multihost allow-non-eap-enable command to allow non-
EAPOL clients.
2. Ensure that there are no errors after execution.
Showing EAPOL multihost interface
Display the EAPOL multihost interface information.
1. Enter the show eapol multihost interface <port#> command to display
the information.
2. Ensure that Allow Non-EAPOL clients is enabled.
3. Ensure that the Multihost status is enabled.
Enabling multihost status and allow non-EAPOL clients
Correct the non-EAP client attribute.
1. Use the eapol multihost allow-non-eap-enable command to allow non-
EAPOL clients.
2. Use the eapol multihost enable command to enable multihost status.
Showing EAPOL multihost non-eap-mac interface
Display the EAPOL multihost interface information.
1. Enter the show eapol multihost non-eap-mac interface <port> command to display
the information.
2. Note that the MAC address is in the list.
Configured MAC is not authenticating
Troubleshooting 5.1 February 2013 103
To Next Page
Loading...
