Figure 36: Enable EAP globally
Enabling EAP globally
Enable EAP globally on the Ethernet Routing Switch 3500 Series device.
1. Use the eapol enable command to enable EAP globally on the 3500 Series
device.
2. Ensure that there are no errors after command execution.
Viewing EAPOL settings
Review the EAPOL settings to ensure EAP is enabled.
1. Use the show eapol port <port#> command to display the information.
2. Observe the output.
Troubleshooting authentication
92 Troubleshooting 5.1 February 2013
Comments? infodev@avaya.com
To Next Page
Loading...
