Selecting a base unit using the UI/Mode Select button
This procedure describes the steps necessary to set the base unit using the UI button.
Note:
The UI button is labeled Mode Select on Avaya branded equipment.
1. Press and hold the UI button for three seconds. The unit is now in configuration
mode. The color and status of the Status LED turns to blinking green.
2. Press the UI button once. The Base LED is illuminated and the Up and Down LEDs
are off to indicate that the button press was recognized.
3. Press and hold the UI button for three seconds to confirm the command. The Status
LED returns to a steady green state to confirm command acceptance. If the
command is rejected, the Status LED moves to a blinking amber state.
Setting non-base units
The following procedure describes the steps to set the units as non-base switches.
Set the Unit Select switch set to the left to designate them as non-base units.
Setting non-base units using the UI/Mode Select button
This procedure describes the steps necessary to set a non-base unit using the UI button.
Note:
The UI button is labeled Mode Select on Avaya branded equipment.
Stack configuration
Avaya Ethernet Routing Switch 5000 Series Installation December 2010 89
To Next Page
Loading...
