1. Press and hold the UI button for three seconds. The unit is now in configuration
mode. The color and status of the Status LED turns to blinking green.
2. Press the UI button twice. The Base LED will turn off and the Up and Down LEDs
are turned off.
3. Press and hold the UI button for three seconds to confirm the commands. The
Status LED returns to a steady green state to confirm command acceptance. If the
command is rejected, the Status LED moves to a blinking amber state.
Resetting a stack using the UI/Mode Select button
The following procedure describes the steps to reset the stack using the UI button.
Note:
The UI button is labeled Mode Select on Avaya branded equipment.
1. Press and hold the UI button for three seconds.
The unit is now in configuration mode. The color and status of the Status LED turns
to blinking green.
2. Press the UI button three times.
The Base, Up, and Down LEDs will move to a blinking amber state and blink in
unison.
3. Press and hold the UI button for three seconds to confirm the command.
Hybrid stack recommendations and limitation
Recommendations:
• The 5600 must be a base unit.
• 5600s must be adjacent.
• For 5600 to 5600, use the new stack cables (blue cables).
• For 5600 to 5500, use either the new stack cables (blue cables) or the old ones.
Limitation:
When stacking a 5632FD with any 5500 model, the last two 10gBE ports (31 and 32) of all
5632s are disabled (you do not see port 31 and 32 on the show tech). This limitation only exists
in Hybrid Stacks, and is regardless of whether 5632s are adjacent to other 5632s or 5500s.
Procedures for installation of the switch
90 Avaya Ethernet Routing Switch 5000 Series Installation December 2010
To Next Page
Loading...
