About the general download process
Issue 3 January 2014 57
The following are example settings only. Your settings will vary from the settings shown. This
sample assumes specification of a DNS Server, identifying SIP-specific settings, and setting the
time/date.
##
Define the Domain Name Server to be "dns.example.yourco.com"
## Note that quotes are only needed for parameters that contain spaces.
SET DNSSRVER dnsexample.yourco.com
## SIP Proxy/Registrar servers list
## SIP_CONTROLLER_LIST provides ability to configure SIP Proxy/Registrar list.
## The format is host[:port];[transport:xxx]. A comma seperated list in this
## format can be provided. Host can be DNS name or IP address. Port is optional.
## If port is not specified then default value of 5060 for TCP and UDP and 5061 for
## TLS will be used. Transport type is optional. It can be tcp or udp or tls.
## Default value of tls will be used if it is not provided.
SET SIP_CONTROLLER_LIST proxy1,proxy2:5070;transport=tcp
## Presence Enabled
## Determines whether presence functionality is
## enabled on the phone.
## 0 for No
## 1 for Yes
SET ENABLE_PRESENCE 1
## SIPDOMAIN sets the domain name to be used during
## registration. The default is null ("") but valid values
## are 0 to 255 ASCII characters with no spaces.
SET SIPDOMAIN example.com
## SNTPSRVR sets the IP address or Fully-Qualified
## Domain Name (FQDN) of the SNTP server(s) to be used.
## The default is null ("") but valid values are zero or
## more IP addresses in dotted-decimal or DNS format,
## separated by commas without intervening spaces, to a
## maximum of 255 ASCII characters.
## You may also want to use the ntp pool of servers.
## See http://www.pool.ntp.org/use.html
SET SNTPSRVR 192.168.0.5
## GMTOFFSET sets the time zone the phone should use. The
## default is -5:00; see the 9600 Series SIP Deskphone LAN
## Admin Guide for format and setting alternatives.
SET GMTOFFSET "-6:00"
## DSTOFFSET sets the daylight savings time adjustment
## value. The default is 1 but valid values are 0, 1, or 2.
## SET DSTOFFSET "1"
## DSTSTART sets the beginning day for daylight savings
To Next Page
Loading...
