Customizable system parameters for SIP-based 9600 Series IP Deskphones
Issue 3 January 2014 75
DISPLAY_NAME_NUMBER 0 Indicates whether the calling party’s number will be
displayed next to the caller name on an incoming
call. If this parameter is not set, the deskphone
displays only the caller name. Valid values are:
0 = Show caller name only.
1 = Show caller name followed by number.
2 = Show caller number only.
3 = Show caller number followed by name.
Note:
Note: For Avaya Aura
®
CCElite
environment, deskphones display
the VDN name associated with the
call along with the caller name. Use
value 1 or 3 so that the deskphone
always displays meaningful
information even if the caller name
is not available.
DNSSRVR 0.0.0.0 Text string containing the IP Address of zero or
more DNS servers, in dotted-decimal format,
separated by commas with no intervening spaces
(0-255 ASCII characters, including commas).
DOMAIN " " (Null) Text string containing the domain name to be used
when DNS names in parameter values are
resolved into IP Addresses. Valid values are 0-255
ASCII characters.
DOT1X 0 Defines the deskphone's operational mode for
IEEE 802.1X.Valid values are:
0 = Unicast Supplicant operation only, with PAE
multicast pass-through, but without proxy Logoff.
1= Unicast Supplicant operation only, with PAE
multicast pass-through and proxy Logoff.
2= Unicast or multicast Supplicant operation,
without PAE multicast pass-through or proxy
Logoff.
DOT1XEAPS MD5 Specifies the EAP authentication method(s) to be
used with IEEE 802.1X. Comma-separated list of
key words defining EAP methods. Valid values are
either "MD5" or "TLS".
Parameter Name Default
Value
Description and Value Range
To Next Page
Loading...
