Avaya AP-3 - B ASCII Character Chart

Configure Multiple SSID/VLAN/Security Mode Entries
4-140 Avaya Wireless AP-3 User’s Guide
NOTE:
Some parameters on other pages must be configured for each
security mode to function. RADIUS server(s) must be configured to
support authentication of WPA, 802.1x or WEP clients. Encryption
keys must be configured for WEP clients if mixed mode is selected.
Enable WEP Encryption
Follow these steps to set up WEP encryption on an SSID/VLAN:
1. Set Security Mode to WEP (if necessary).
2. Enter Encryption Key 0 only; the transmit key (the key used to
encrypt outgoing data) will be automatically set to zero. Keep in
mind the following:
— For 64-bit encryption, an encryption key is 10 hexadecimal
characters (0-9 and A-F) or 5 ASCII characters (see Appendix
B, Appendix BASCII Character Chart).
— For 128-bit encryption, an encryption key is 26 hexadecimal
characters or 13 ASCII characters.
— For 152-bit encryption, an encryption key is 32 hexadecimal
characters or 16 ASCII characters.
Enable 802.1x Security
Follow these steps to enable 802.1x on an SSID/VLAN pair:
1. Set Security Mode to 802.1x.
2. Select an Encryption Key Length.