Avaya AP-3 - Rogue Access Point Detection (RAD) Parameters; Syntax Examples

RAD Commands
Avaya Wireless AP-3 User’s Guide A-75
Rogue Access Point Detection (RAD) Parameters
Syntax Examples
[Device-Name]> set radstatus enable
[Device-Name]> set radscanint <15-1440>
[Device-Name]> set radifbitmask <4 (WiF A), 8 (WiF B), or 12
(both interfaces)>
[Device-Name]> show rad
Figure A-14. Results of “show rad” CLI command
Name Type Values Access CLI Parameter
Rogue Access Point
Detection (RAD)
Group N/A R rad
Status Integer enable
disable (default)
RW radstatus
Scan Interval Integer 15-1440 (minutes) RW radscanint
Interface Bitmask Interface
Bitmask
4 (WiF A), 8 (WiF B),
or 12 (both).
RW radifbitmask