Management and Monitoring Capabilities
1-10 Avaya Wireless AP-3 User’s Guide
When accessing the CLI via Telnet, you can communicate with the
Access Point from over your LAN (switch, hub, etc.), from over the
Internet, or with a “crossover” Ethernet cable connected directly to your
computer’s Ethernet Port.
See The Command Line Interface for more information on the CLI and for
a list of CLI commands and parameters.
SNMP Management
You can also manage and configure an AP using the Simple Network
Management Protocol (SNMP).
NOTE:
This requires an SNMP manager program, like HP Openview or
Castlerock’s SNMPc.
The AP supports several Management Information Base (MIB) files that
describe the parameters that can be viewed and/or configured over
SNMP:
• MIB-II (RFC 1213)
• Bridge MIB (RFC 1493)
• Ethernet-like MIB (RFC 1643)
• 802.11 MIB
• Avaya Wireless Enterprise MIB
To Next Page
