Auto Configuration Commands
Avaya Wireless AP-3 User’s Guide A-41
Auto Configuration Commands
The Auto Configuration feature automatically configures an AP by
downloading a specific configuration file from a TFTP server during the
boot up process.
Perform the following commands to enable and set up automatic
configuration:
NOTE:
The configuration filename and TFTP server IP address are
configured only when the AP is configured for Static IP. If the AP is
configured for Dynamic IP these parameters are not used and
obtained from DHCP.
The default filename is “config”. The default TFTP IP address is
10.0.0.2 for the AP.
To Next Page
