Configure Multiple SSID/VLAN/Security Mode Entries
Avaya Wireless AP-3 User’s Guide 4-145
2. Set the VLAN Management ID to use the same VLAN ID as one
of the configured SSID/VLAN pairs. See Typical User VLAN
Configurations for details.
3. Place a check mark in the Enable VLAN Protocol box.
Disable VLAN Management
1. Click Configure > SSID/VLAN/Security.
2. Remove the check mark from the Enable VLAN Protocol box to
disable all VLAN functionality.
MAC Access
The MAC Access tab allows you to build a list of stations, identified by
their MAC addresses, authorized to access the network through the AP.
The list is stored inside each AP within your network. Note that you must
reboot the AP for any changes to the MAC Access Control Table to take
effect.
• Enable MAC Access Control: Check this box to enable the Control
Table.
• Operation Type: Choose between Passthru and Block. This
determines how the stations identified in the MAC Access Control
Table are filtered.
— If set to Passthru, only the addresses listed in the Control
Table will pass through the bridge.
To Next Page
