Key combination Function
? Context sensitive help
Esc+C and Exc+U Capitalize character at cursor
Esc+l Change character at cursor to lower case
Esc+B Move back 1 word
Esc+D Delete 1 word to the right
Esc+F Move 1 word forward
Opening an ACLI session
Use this procedure to open an ACLI session for the switch.
Before you begin
• Connect to the switch — either directly, with a console cable connected to the switch
console port, or use Telnet.
• To connect to the switch remotely, use Telnet, enable remote access, and ensure that
the switch IP address is valid.
• Use a terminal or a PC with a terminal emulator as an ACLI command station.
• If you use a console cable and console port, ensure that the terminal emulation program
conforms to settings in the following table.
Property
Value
Baud Rate 9600 bps
Data Bits 8
Stop Bits 1
Parity None
Flow Control None
Terminal Protocol VT100 and VT100/ANSI
Procedure
1. Connect to the switch.
2. Enter the password, if applicable.
3. At ACLI Banner Screen, enter CTRL+Y.
Avaya Command Line Interface fundamentals
16 Fundamentals of ERS 3500 Series March 2014
Comments? infodev@avaya.com
To Next Page
Loading...
