To select an object, click the object. The system outlines the object in yellow, indicating that
the object selected.
The conventions on the device view are similar to the actual switch appearance except that
LEDs in Device Physical View do not blink. The LEDs and the ports are color-coded to reflect
hardware status. Green indicates the port is up and running; red indicates that the port is
disabled.
From the menu bar you can click the Device Physical View tab to open the Device Physical
View any time during a session.
Figure 1: Device Physical View
EDM window
The EDM window contains the following parts:
• 1 navigation tree—the navigation pane on the left side of the window that displays
available command folders in a tree format
• 2 menu bar—the area at the top of the window that displays primary and secondary tabs
that you accessed during the session; the tabs remain available until you close them
Interface components
Fundamentals of ERS 3500 Series March 2014 21
To Next Page
Loading...
