2. At the command prompt, enter the following command:
no web-server enable
Displaying the Web server status using ACLI
Use the following procedure to display the status of the Web server using ACLI.
Procedure
1. Log on to the Global Configuration mode in ACLI.
2. At the command prompt, enter the following command:
show web-server
Configuring the path to the help files using ACLI
Use this procedure to configure the path to the help files.
Procedure
1. Log on to the Global Configuration mode in ACLI.
2. At the command prompt, enter the following command:
edm help-file-path <path name> <tftp address> <filename>
Example
Following is an example of an ACLI EDM help file path:edm help-file-path
ERS3500_51_Help tftp address 10.100.100.15
In the preceding example, ERS3500_51_Help is a folder that contains help files and the folder
is located on a TFTP server at the 10.100.100.15 address.
ACLI procedures
34 Fundamentals of ERS 3500 Series March 2014
Comments? infodev@avaya.com
To Next Page
Loading...
