Avaya ERS 3500 Series - Saving Current Configuration to Flash Memory Manually Using EDM

6. In Action, select dnldConfig.
7. On the toolbar, click Apply.
Config Image Diag file tab field descriptions
The following table describes the fields on the Config/Image/Diag file tab.
Name Description
TftpServerInetAddressType Specifies the IP version of the TFTP server
address.
TftpServerInetAddress Specifies the TFTP server IP address.
BinaryConfigFilename Specifies the name of the binary
configuration file.
Action
• dnldConfig—Downloads a configuration
file to the switch.
• upldConfig—Uploads a configuration file to
the switch from a designated location.
• dnldImg—Downloads a new software
image to the switch.
• dnldImgIfNewer—Downloads a new
software image to the switch only it if is
newer than the current image.
• dnldImgNoReset—Downloads a new
software image to the switch without a
switch reset.
• dnldFW—Downloads a new diagnostic
software image to the switch.
• dnldFwNoReset—Downloads a new
diagnostic software image to the switch
without a switch reset.
Saving current configuration to flash memory manually using EDM
Use this procedure to save the current configuration to flash memory manually.
Procedure
1. In the navigation tree, double-click Edit to open the Edit tree.
2. Double-click File System.
3. Choose Save Configuration.
Enterprise Device Manager configuration files
Fundamentals of ERS 3500 Series March 2014 55