Config Image Diag file tab field descriptions
The following table describes the fields on the Config/Image/Diag file tab.
Name Description
TftpServerInetAddressType Specifies the IP version of the TFTP server
address.
TftpServerInetAddress Specifies the TFTP server IP address.
BinaryConfigFilename Specifies the name of the binary
configuration file.
Action
• dnldConfig—Downloads a configuration
file to the switch.
• upldConfig—Uploads a configuration file to
the switch from a designated location.
• dnldImg—Downloads a new software
image to the switch.
• dnldImgIfNewer—Downloads a new
software image to the switch only it if is
newer than the current image.
• dnldImgNoReset—Downloads a new
software image to the switch without a
switch reset.
• dnldFW—Downloads a new diagnostic
software image to the switch.
• dnldFwNoReset—Downloads a new
diagnostic software image to the switch
without a switch reset.
Status Displays the status of the most recent action
since the last switch restart.
Downloading a binary configuration file on a TFTP server using EDM
Use this procedure to download a binary configuration file on a TFTP server.
Procedure
1. In the navigation tree, double-click Edit to open the Edit menu.
2. Double-click File System.
3. Click the Config/Image/Diag file tab.
4. In TftpServerInetAddress, enter the TFTP server IP address.
5. In BinaryConfigFilename, enter the configuration file name.
Configuration files fundamentals
54 Fundamentals of ERS 3500 Series March 2014
Comments? infodev@avaya.com
To Next Page
Loading...
