Procedure
1. Log on to the Privileged EXEC mode in ACLI.
2. At the command prompt, enter the following command:
copy running-config tftp [address (<A.B.C.D> | <WORD>)]
[filename <WORD>]
Variable definitions
The following table describes the parameters for the copy running-config command.
Variable Value
address<A.B.C.D> Specifies the address of the TFTP server.
• A.B.C.D — specifies the IP address
filename<name> Specifies the configuration file name.
Saving current configuration to flash memory using ACLI
Use this procedure to save the current configuration to flash memory. Note that the system
automatically issues the copy config nvram command periodically.
Procedure
1. Log on to the Privileged EXEC mode in ACLI.
2. At the command prompt, enter the following command:
copy config nvram
Note:
The current configuration can also be saved to Non-Volatile RAM (NVRAM) using
the write memory command or the save config command. Both of these
commands are also issued from Privileged EXEC command mode.
Restoring system configuration from TFTP using ACLI
Use this procedure to restore the system configuration from TFTP.
Configuration files fundamentals
48 Fundamentals of ERS 3500 Series March 2014
Comments? infodev@avaya.com
To Next Page
Loading...
