Avaya ERS 3500 Series - Chapter 6: Translations of safety messages; Class A electromagnetic interference warning statement

Procedure
1. Log on to the Privileged EXEC mode in ACLI.
2. At the command prompt, enter the following command:
copy tftp config address <A.B.C.D> filename <name>
Variable definitions
The following table describes the parameters for the copy tftp config command.
Variable Value
address <A.B.C.D> Specifies the address of the TFTP server.
• A.B.C.D — specifies the IP address
filename <name> Specifies the configuration file name.
Downloading a configuration file automatically using ACLI
Use this procedure to configure a switch to automatically load a configuration file.
Procedure
1. Log on to the Privileged EXEC mode in ACLI.
2. At the command prompt, enter the following command:
configure network load-on-boot {disable | use-bootp | use-
config} address <A.B.C.D> filename <name>
Variable definitions
The following table describes the parameters for the configure network load-on-boot
command.
ACLI configuration files
Fundamentals of ERS 3500 Series March 2014 49