• For external mount:
1. Position the camera on the external monitor and open the camera leg to balance the
camera properly.
2. Plug one end of the camera cable into the camera connector of the Collaboration Station.
Plug the other end into the connector in the camera.
3. Plug one end of the video cable into the video display out connector of the Collaboration
Station. Plug the other end into the video display in connector of the external monitor.
Related links
Hardware setup and login on page 45
Camera on page 60
Camera LED states
The front panel of the camera contains a red LED that turns on when the camera is capturing
pictures. The LED has the following states.
State Description
Off Camera is not connected or video is blocked.
Steady on Camera is operating and capturing live video.
Blink Camera is powered up and the Collaboration Station is performing the camera
software update.
Related links
Camera on page 60
Camera notifications
The camera provides the following notifications on the Top Bar.
Notification
Description
Camera update in
progress
Indicates that camera upgrade has started.
Incorrect camera
connection
Indicates that the camera is connected to the wrong port.
Unsupported device
on the camera port
Indicates that an unsupported device is connected to the camera port.
Camera firmware
required
Indicates that the camera software upgrade is required.
Related links
Camera on page 60
Camera
April 2016 Using Avaya H175 Video Collaboration Station 63
Comments on this document? infodev@avaya.com
To Next Page
Loading...
