Option Description Option Description
Enable VAD Use this check box to
enable the Voice Activity
Detection (VAD). When
enabled, the device
suppresses the audio
transmission with
artificial comfort noise
signal to save the
bandwidth.
Enable MWI Tone Use this check box to
enable playing the MWI
tone when a new MWI
comes.
Configuring alert info ring settings
About this task
Use this procedure to set distinctive ringtone for incoming calls.
Procedure
1. On the web portal, navigate to Phone settings > Alert Info Ring Settings.
2. In the Value field, enter the extension number.
3. In the Ring Type drop down, select the ringtone.
4. Click Apply.
MCAST page
To access this page, click the Phone settings tab and then click MCAST.
This feature allows you to make a broadcast call to people who are in a multicast group. You can
configure a multicast DSS Key on the phone to send an RTP stream to the pre-configured
multicast addresses without involving SIP signaling. You can also configure the phone to receive
an RTP stream from pre-configured multicast listening addresses without involving SIP signaling.
You can specify up to 10 multicast listening addresses
The following table describes the MCAST settings to be configured for the Avaya H239 and H249
phones:
Option
Description
Priority The priority of the active call: 1 is the highest priority
and 10 is the lowest.
Enable Page Priority The voice call in progress takes precedence over all
incoming paging calls.
Name Multicast server name.
Host:port Multicast server’s multicast IP address and port.
Web portal navigation
October 2019 Installing and Administering the Avaya H239 and H249 Phones 36
Comments on this document? infodev@avaya.com
To Next Page
