Avaya J100 - Page 220

Parameter name Default
value
Description
Note:
The parameter is set to 0 for
IP Office environment.
ENABLE_SIP_USER_ID 0 Specifies that the SIP User ID field
is required under ADMIN > SIP >
SIP Global Settings.
Value Operation
• 0: Disabled
• 1: Enabled
ENABLE_STRICT_USER_VALIDATION 0 Specifies that the validation is done
for the To header and Request-
URI against AOR and Contact
header during phone registration.
Value Operation
• 0: No validation.
• 1: Validates the phone
registration.
ENCRYPT_SRTCP 0 Specifies whether RTCP packets
are encrypted or not. SRTCP is
only used if SRTP is enabled using
MEDIAENCRYTIONRTCP.
ENCRYPT_SRTCP parameter
controls RTCP encryption for RTCP
packets exchanged between peers.
RTCP packets sent to Voice
Monitoring Tools are always sent
unencrypted.
Value Operation:
• 0: SRTCP is disabled.
• 1: SRTCP is enabled.
ENFORCE_SIPS_URI 1 Specifies if a SIPS URI must be
used for SRTP.
Value Operation:
• 0: Not enforced
• 1: Enforced
ENHDIALSTAT 1 Specifies if the algorithm defined by
the parameter is used during
certain dialing behaviors.
Table continues…
Appendix
December 2018 Installing and Administering Avaya J100 Series IP Phones 220
Comments on this document? infodev@avaya.com