Avaya J100 - Page 221

Parameter name Default
value
Description
Value Operation:
• 0: Disables algorithm.
• 1: Enables algorithm, but not for
contacts.
• 2: Enables algorithm including
contacts.
Note:
The parameter is set to 0 for
IP Office environment.
ENTRYNAME 0 Specifies if the calling party name,
or the VDN or the skill name must
be used in History entries.
Value Operation:
• 0: Calling Party Name is used.
• 1: VDN or the skill name is used.
EVENT_NOTIFY_AVAYA_MAX_USERS 20 Specifies the maximum number of
users to be included in an event
notification message from CM/AST-
II or Avaya Aura
®
Conferencing 6.0
or later.
Valid values are 0 through 1000.
This parameter is used only for
development and debugging
purposes.
EXCHANGE_AUTH_USERNAME_FORMAT 0 Specifies the necessary format of
the username for http
authentication.
Value operation:
• 0: Office 2003/Office2016
username format. Username=
<ExchangeUserDomain
\ExchangeUserAccount> or
Username=
<ExchangeUserAccount> if
<ExchangeUserDomain> is
empty.
• 1: Office 365 format. Username=
<ExchangeUserAccount@Excha
ngeUserDomain> or Username=
<ExchangeUserAccount> if
Table continues…
List of configuration parameters
December 2018 Installing and Administering Avaya J100 Series IP Phones 221
Comments on this document? infodev@avaya.com