Avaya one-X - Configuring Video Settings

Configuring video settings
Procedure
1. Click Video in the left pane of the General Settings window.
2. Select the Send your video image automatically when you answer or join a video call
check box, if required.
3. To enable Picture in Picture (PIP) and configure the PIP settings, select the Display a
picture-in-picture window check box and select one of the following options:
• Select Small picture-in-picture window check box.
• Select Medium picture-in-picture window check box.
• Select Large picture-in-picture window check box.
4. To keep the PIP window fixed at a location, select the Fixed picture-in-picture window
check box.
5. Select the Stretch video to fit screen check box, if required.
6. Select the Display warning before entering Full Screen mode check box, if required.
7. Select the Automatically disable screen saver and monitor power saving mode during
a call check box, if required.
8. Click the Advanced tab and configure the following:
a. Select a camera from the Preferred Camera drop-down menu.
b. Select a preferred bit rate from the User Session Maximum Bit Rate drop-down menu.
For video conference in SIP mode using Avaya Aura
®
Conferencing, you must set the
User Session Maximum bit rate to at least 384 kbps.
c. Select the Show the video window automatically on login with video capabilities
check box, if required.
9. Click the Administration tab and select the Codecs.
10. Click OK.
Note:
Video feature is not supported when you are using Avaya one-X
®
Communicator through
a remote desktop connection or a virtual computer. For more information on video
settings, see Using Avaya one-X
®
Communicator on the Avaya Support Web site
http://
www.avaya.com/support.
Configuring the general settings manually
34 Implementing Avaya one-X
®
Communicator April 2015
Comments? infodev@avaya.com