Avery Dennison 6405 - Tension Arm; Bearing Bushes

03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
12
Tension arm
Design changes
Serial no.
Date
Changed item
0663910
06/2006
Simple tension arm spring
(type 1) was replaced by
spring with rope drive and
pulley (type 2).
Rectangular self-adhesive
stoppers were replaced by
cylindrical screw-in stoppers.
Disassembling/assembly
Type 1:
1. Unmount the spring (1) from the
nose(2).
Type 2:
1. Unmount the wire hook (3).
2. Draw the tension arm (5) off the axle (6).

Lightly grease the axle to allow the firmly
sitting tension arm to be moved more
easily.
 During assembly:
Check the free movement of the tension
arm.
The tension arm must move between
the two strokes (4).
Tool
– Phillips screwdriver
Bearing bushes
Disassembling/assembly
 First remove the clamping ring and then
the three bearing bushes (7).
5
6
7
1
2
3
4
4