03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
70
Centronics board
The Centronics board (1) is mounted as a
standard to the lower recess in the rear wall.
Centronics interface and I/O board can
not be mounted into the same device!
Part number Centronics board: A6756
Tool
2 mm Allen key
Dismantling
1. Remove rear hood.
How? – See section Rear hood on
page 7.
2. Remove power supply.
See section Power Supply on page 52.
3. Unplug the connection cable from the
CPU board.
4. Remove both screws (2) from the
mounting bracket. Remove board.
Assembly notes
Connect the board to the CPU board as
figured.
A Connector on the CPU board (CN300)
(fig. below)
The (silver coloured) contacts of the
cable must show to the right when
connecting it
1
1
2
2
1
A
To Next Page
Loading...
