Avery Dennison 6405 - Overview of Printhead Settings; Adjusting the Printhead Position; Adjusting the Printhead Contact Pressure; Adjusting the Printhead Aperture

03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
42
Overview of printhead settings
There are electronic and mechanical settings:
Electronic settings Parameter When required?
Print contrast SYSTEM PARAMETER >
Print contrast
*
Blackening of the printout is too low (depends on
material/foil combination)
Printhead resistance SYSTEM PARAMETER >
Head resistance
After each printhead exchange
Printhead
temperature
compensation
SYSTEM PARAMETER >
Temp. reduction
Label layout with huge areas of blackening and
smearing of tiny structures, see user manual,
topic section „Advanced Applications“, chapter
„Printing with temperature compensation“.
Mechanical settings When required?
Adusting the printhead position After printhead exchange, if the printout is
considerably worse, see chapter Adjusting the
printhead position on page 46.
Adusting the printhead contact pressure After removal of the printhead contact pressure
lever, see chapter Adjusting the print head
contact pressure on page 47.
Adjusting the printhead aperture After removal of the printhead motor, see chapter
Adjusting the head aperture on page 44.
*
) Alternatively, in online mode: prog button