03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
64
Boards (Gen. 3)
Operation panel
Dismantling
1. Remove rear hood.
How? – See section Rear hood on
page 7.
2. Reach behind the housing from above to
push the control panel (1) out forwards.
Do not press the board. Press the
expansion plug instead.
3. Unplug the cable from the operation
panel board.
Assembly
If the connection cable has been
replaced: Plug the sensor into plug
CN702 (3) on the CPU board.
Relay and attach the cable, making sure
it does not touch any moving parts.
Details about the operation panel see
topic section “Electronics (Gen. 3)”.
2
1
3
To Next Page
Loading...
