Avery Dennison 6405 - Cable Harness D-Sub Connector

03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
55
Cable harness D-Sub connector
CAUTION!
Connecting non-original devices to this interface can damage the printer.
In the worst case the printer can start to burn.
 Only connect original Avery Dennison peripheral devices to this
interface.
The D-Sub connector (1) at the front side of the printer serves as a
connection for all optional devices (like cutter, rewinder, ...). By means of a
cable harness (2, see Fig. 2), the plug is connected to four different points:
•
Motordriver board
•
CPU board
•
Power Supply
•
Printer bottom
Fig. 2 Cable harness which is connected to the D-Sub connector at the printer front side.
Pin assignment
Fig. 3 Pin assignment of the D-Sub connector.
Connecting See Fig. 4 overleaf.

2
1
12345678
9
101112131415
Sensor 2 Emitter GND
Sensor 2 Collector
Sensor 1 Collector
Sensor 1 Emitter GND
5 V
n. a.
Motor A\
Motor A
Sensor 2 Cathode
Sensor 2 Anode
Sensor 1 Anode
5 V GND
GND
Motor B\
Motor B