03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
38
Material guide
The axles of the material guides are fixed to
the sheet plates on the side by clamping rings.
The outer material can be moved freely along
the axles. The inner guide is fixed in the zero
position by a grub screw.
The material end photoelectric switch is
integrated in the inner material guide.
Disassembling
1. Unscrew the thumb screw (1) on the
outer material guide.
2. Unscrew the Allan key grub screw (2) on
the inner material guide.
3. Push the grip ring (3) on the front
material guide to the middle of the axle.
4. Push the axle out of the side parts (4).
5. Remove the grip ring, clamping ring and
material guide from the axle.
Assembly
1. Join the material guide and axle back
together again (pay attention to the
photoelectric switch).
2. Bring the inner and outer clamping rings
back into position.
3. Fix the inner material guide in the zero
position.
The grub screw in the rear material
guide must reach into the groove of the
axle:
standard printer: rear groove (5)
printer with spender: front groove
4. Set the outer material guide to the
material width and affix it with the thumb
screw.
Tools
– Allan key 1.5 mm
– Grip ring pliers
4
4
3
1
2
5
To Next Page
Loading...
