03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
80
Dustfilter for 64-08 up to serial
number 075580
For the use of the 64-08 in a dusty
surrounding, an optional dustfilter (1) is
available (article no. A6206).
WARNING! – Fire hazard!
If this dust filter is mounted to a
64-04/-05 or -06 printer with the old
standard power supply NT400
(article no. A1680), there is a
danger of overheating the power
supply.
Mount the dust filter only to
64-08 printers.
Tools
•
3 mm hex socket screwdriver
•
Cross-head screwdriver, medium size
•
Screwdriver, medium size
Assembling the dust filter
1. Put a liner (4) into the filter housing (3).
2. Press the filter housing onto the filter
frame (2). Turn the screw (5) by a
quarter-turn.
Mounting
1. Switch off the printer; unplug the power
cord.
2. Unscrew the 2 scews (5) at the printers
rear side.
3. Screw the dust filter (6) onto the tapped
holes using the screws which came with
the filter kit (1).
CAUTION! -
An exhausted filter liner can cause
the power supply to overheat and
the device to break down.
Replace the filter liner regularly,
at least in monthly intervals.
For notes about cleaning/replacing the
filter read the user manual, topic section
“Maintenance”.
1
2
3
4
5
5 5
6
To Next Page
Loading...
