Avery Dennison 6405 - Print Module Removal Steps

03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
34
4. Unscrew and remove the stabiliser (2) in
the mechanical part (1 Allan key screw
at top and bottom).
5. Detach the earth connection (3) of the
print module from the housing.
6. Unscrew the fastening screws (4) of the
print module (eight Allan key screws).
7. Pull out the print module to the rear (5).
Tools
– Allan key 3 mm
– Allan key 2 mm
– Phillips size 1
2
3
4
4
4
4
4
4
4
4
5