03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
53
Assembly
To assemble the device, follow the steps in
the reverse order. While doing so, pay
attention to:
WARNING
Hazard caused by dangerous
contact voltage.
Attach the ground cable to the
printer wall.
After assembling, check the
printer according to the
regulations relevant in your
country.
Tighten the screws cautiosly.
Connect the power supply as illustrated:
Fig. above: HME (64-08)
Fig. below: ME500 (64-04/05/06)
(1) Output stages (cable no. A1189)
(2) Cable harness for cutter connector
(cable no. A1191)
(3) USI (if available)
(4) CPU supply voltage
(Æ CN 1401)
(5) Printhead
(6) CPU data bus
(7) Bridge this connector with a jumper
(8) Screw the ground cable to the printer
rear side; assemble the parts in the
following order to the threaded bolt:
Serrated lock washer – Eyelet - Serrated
lock washer – Nut.
The cable at the eyelet must show
diagonally downwards.
1
1
3
3
4
4 2
2
5
5
6
6
7
7
HME
ME500
8
9
To Next Page
Loading...
