03/10 Rev. 5.04-04 SERVICE MANUAL Service Mechanics
64-xx – 64-xx Dispenser
68
Ribbon motor:
Connect the board according to the right
figure.
A Ribbon motor sensor (RS)
B Ribbon motor (RM)
C Voltage supply from the power pack
D Data bus from the CPU board
Printhead motor:
Connect the board according to the right
figure.
A Printhead sensor (HS)
B Printhead motor (HM)
C Voltage supply from the power pack
D Data bus from the CPU board
Periphery motor:
Connect the board according to the right
figure.
A Periphery sensor (OS)
64-xx Dispenser: Sensor must be
connected to the CPU board instead.
B Periphery motor (OM)
C Voltage supply from the power pack
D Data bus from the CPU board
Rewinding motor:
Connect the board according to the right
figure.
A Rewinding motor (WM)
B Voltage supply from the power pack
C Data bus from the CPU board
For further information about the output
stage boards read the service manual,
topic section “Electronics (Gen. 3)”,
chapter “Output stage board”..
A
B
C D
A
B
D C
A
C
B
A
B
C D
To Next Page
Loading...
