13) For products containing a lithium battery:
Warning! Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
14) For products with a power switch:
It should remain accessible after installation.
15) The equipment shall be used at a maximum ambient temperature of 40° C and maximum altitude of 2000m.
16) For products with an operator-accessible fuse:
CAUTION: For continued protection against risk of fire, replace only with same type and rating of fuse.
ATTENTION: Pour ne pas compromettre la protection contre les risques d'in- cendie, remplacer par un fusible de même type et de
même caractéristiques nom- inales.
17) For products that are not rack-mountable: Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold
with the equipment. When a cart is used, use caution when moving the cart/equipment combination to avoid injury from tip-over.
18) Rack-Mount Safety Instructions
1) Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack
environment might be greater than room ambient. Therefore, consider installing the equipment in an environment compatible with
the maximum ambient temperature (Tma) specified by the manufacturer.
2) Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air flow required for safe operation
of the equipment is not compromised. Stage 48 airflow is from the front of the chassis enclosure to the rear. Make allowances for
cooling air to be available to the front panel surface and no restrictions at the rear.
3) Mechanical Loading - Mounting of the equipment in the rack should be such that a hazardous condition is not achieved due to
uneven mechanical loading.
4) Circuit Overloading - Consideration should be given to the connection of the equipment to the supply circuit and the effect that
overloading of the circuits might have on overcurrent protection and supply wiring. Appropriate consideration of equipment
nameplate ratings should be used when addressing this concern.
5) Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained. Particular attention should be given to
supply connections other than direct connections to the branch circuit (for example, use of power strips).
To Next Page
Loading...
Need help?
General
