MBOX Control Software Overview
32
EQ
The lower section of Channel Focus is the built-in EQ.
Based on Avid ChannelStrip, MBOX EQ can be used either on channel feeds to MBOX outputs such as headphones, or applied to chan-
nel feeds to Pro Tools. Each Hardware Input channel (including Talkback) can have their own Channel Focus EQ settings.
EQ Controls
EQ in Channel Focus
AVID FX EQ
Item Description
Bypass When enabled (lit) the effect of the EQ is silenced.
EQ to DAW
When enabled (lit) EQ is applied to channel feeds going to Pro Tools. When not enabled, EQ is only applied to chan-
nel feeds to MBOX hardware outputs.
Bands LF (Low Frequency), LMF (Low-Mid Frequency), HMF (High-Mid Frequency), HF (High Frequency), Each with:
Band On/Off
Toggles that band in/out (on/off)
Freq
Sets the center frequency for that band
Gain
Boosts or attenuates the corresponding frequencies for that band
Q
Changes the width of the band.
• With the HF or LF band set to Peak, the Q control changes the width of the EQ band. (Higher Q values represent
narrower bandwidths. Lower Q values represent wider bandwidths.)
• With the HF or LF band set to Shelf, the Q control changes the Q of the shelving filter. Higher Q values represent
steeper shelving curves. Lower Q values represent broader shelving curves.
Filter Type
(HF and LF only)
Sets the HF or LF band to Peak or Shelf
For instructions, see Using AVID FX EQ.
To Next Page
Loading...
Need help?
General
